Make your very own Easter Bonnet

Time to get creative with this spectacular Easter bonnet! A fun, simple way to pass the time and a great way to let their little arty imaginations run wild 다운로드.

Here is everything you will need and a step to step guide on how to make the most spectacular Easter Bonnet.

Equipment

  • Hot melt mini glue gun
  • Scissors
  • PVA Glue
  • Green shredded tissue paper
  • Pipe Cleaners
  • Foam Sheets
  • Polystyrene Eggs
  • Daisies (you can make these from card)
  • Easter Bonnet
  • Little Easter chicks
  • Any other decoration you wish to add 디태치먼트 다운로드!

Step-1

Using the green Fab Foam, cut out the grass as shown in the picture 다운로드. Do this with three A5 sheets, then trim about 3cm off of the long edge of two more foam sheets and cut some shorter grass out in the same way.

Step-2

Using a glue gun, apply glue to the bottom edge of the grass and stick around the crown of the hat 아이콘 취향저격 다운로드. You will need to trim the third piece to fit in the remaining gap. Use the glue gun to stick the blades on further higher up as shown. Apply a second layer of grass over the top of the first, trying to make the grass blades fit into the gaps of the first layer of grass 다운로드.

Step-3

Add the smaller layer of grass on top of the other two 다운로드. Curl the blades outwards using a pencil.

Step-4

Select your pipe cleaner colours 다운로드. Twist the pipe cleaners around something (I used a long paint brush). You will need twelve of these altogether. At the bottom end of the twisted pipe cleaner you will need to bend the pipe cleaner around into a circle to help attach to the hat 노라조 슈퍼맨.

Step-5

Glue six pipe cleaners around the crown of the hat about 5cm in from the edge, then six more inside these 다운로드.

Step-6

Push eggs onto the outside set of pipe cleaners and then add embellishments of your choice to the inside set using a glue gun 다운로드.

Step-7

Twist three pipe cleaners together leaving about 3cm free to make a tripod at the bottom. Glue this to the very middle of the crown of the hat and add a larger embellishment of your choice to the top.

Step-8

Glue shredded green tissue paper to the crown of the hat to hide the bottom of the pipe cleaners using PVA glue.

Step-9

Glue shredded tissue paper to the brim of the hat.

Step-10

Add embellishments of your choice around the bottom of the crown. Get as creative as you can with this part! It is lots of fun.

And there you have it! Your very own Easter bonnet.

Find more craft ideas at www.hobbycraft.co.uk

View All